#WDS CHANGE ASUS MAC ADDRESS HOW TO#
This setting would prevent wireless STAs from associating to the AP, but still connect the W元00g back to the Belkin AP via a wireless link. This is a Tutorial on how to change your Mac Address for your Asus Motherboard, or any Motherboard with a Intel NICSo if your Mac Address is 88:88:88:88:87:8. Note again, that if you just wanted to set up a wireless bridge between two wired LANs, you would change the W元00g’s AP Mode from Hybrid to WDS only.
To get the best performance, please go to. Key in the remote AP mac in the remote AP list and open the remote APs WDS management interface, key in the this routers MAC address.
Ensure that this wireless router and the AP you want to connect to use the same channel. This makes things somewhat clearer, but I find the separate Connect to APs in Remote Bridge List ? and Allow Anonymous ? radio buttons more confusing than the Belkin’s single checkbox and associated MAC address entries.Īt any rate, Figure 4 shows the proper W元00g settings for WDS-based repeating, including the MAC address of the Belkin AP in the Remote Bridge List. Select WDS Only or Hybrid mode and add MAC address of APs in Remote AP List. The W元00g uses a graphic to illustrate the wireless connections supported in each of its three modes : AP only, WDS only and Hybrid. bridging.įigure 4 shows the WDS settings for the ASUS W元00g that forms the other end of the WDS link. It would only provide a wireless link to the listed WDS-enabled APs, connecting them back to the wired LAN, i.e. Wireless MAC filter allows you to control packets from devices with specified MAC address in your Wireless LAN. In the MAC Filter List, enter the MAC Address of the device that. Set the MAC Filter Mode to either Accept or Reject depending on the type of filter that will be used.
Choose either 2.4GHz or 5GHz as the frequency that will be used for the filter. If I had checked this selection, then the Belkin would no longer function as an access point, i.e. Click the Wireless MAC Filter tab at the top of the screen. The Disable ability for Wireless CLIENTS to connect checkbox is left unchecked because this WDS setup is being used to extend a wireless LAN, i.e.
0 kommentar(er)
